Lenovo ThinkCentre M93z 10AC User Manual page 75

This section provides instructions on how to replace the integrated camera.
Note: The integrated camera is available only in some models.
To replace the integrated camera, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay
it down so that the screen is against the surface and the cover is facing up.
3. Remove the computer cover. See "Removing the computer cover" on page 46.
4. Locate the integrated camera. See "Locating components" on page 15.
5. Note the routing of the integrated camera cable and then disconnect the integrated camera cable from
the system board. See "Locating parts on the system board" on page 16.
6. Remove the two screws
integrated camera from the computer.
Figure 33. Removing the integrated camera
7. Route the new integrated camera cable and then position the new integrated camera in place. Align the
two screw holes in the new integrated camera with those in the front bezel.
8. Reinstall the two screws to secure the new integrated camera to the front bezel.
9. Connect the integrated camera cable to the system board. See "Locating parts on the system board"
on page 16.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 75.
1
that secure the integrated camera to the front bezel, and then remove the
.
Chapter 5 Installing or replacing hardware
63