Lenovo ThinkCentre M93z 10AC User Manual page 63

1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay
it down so that the screen is against the surface and the cover is facing up.
3. Remove the computer cover. See "Removing the computer cover" on page 46.
4. Locate the hard disk drive in the computer. See "Locating components" on page 15.
5. Press the clips of the hard disk drive bracket inward, and then slide the hard disk drive to the left to
remove it from the chassis.
Figure 19. Removing the hard disk drive
6. Flex the sides of the hard disk drive bracket properly to remove the hard disk drive out of the bracket.
7. To install the new hard disk drive into the bracket, flex the bracket and align pin
4 on the bracket with the corresponding holes in the hard disk drive.
Figure 20. Installing the hard disk drive into the bracket
1 , pin
.
Chapter 5 Installing or replacing hardware
2 , pin 3 , and pin
51