Accessing The Extender's Gui - ActionTec WCB6200Q User Manual

Accessing the Extender's GUI

The Extender features an onboard graphical user interface (GUI) that
includes user-configurable settings. Some of these settings should be
accessed by experienced network technicians only.
To configure the network settings of the Extender:
1. Ensure that the Extender is connected to a gateway/modem's MoCA
coaxial network, and that both devices are powered on.
2. On a computer connected to the same network as the gateway/
modem and Extender, log in to the gateway/modem's GUI. Find the
list of devices that are connected to your gateway/modem.
3. Find the Extender by its MAC ID from the list of connected devices
or status screen. The MAC ID of the Extender is provided on a sticker
located on the rear panel of the Extender, as shown below.
4. Write down the IP address of the Extender.
10