Using Coaxial Splitter - ActionTec WCB6200Q User Manual

6. Wait until the Coax and Wireless LEDs on the front panel of the
Extender glow green. This may take a few minutes. If the Coax Light
does not turn Green, make sure that your gateway/modem supports
MoCA.
The Extender is now synced, installed, and extending the gateway/
modem's wireless network in a previously weak area.
Using a Coaxial Splitter
If another device is using the coaxial outlet needed from step 3 in the
previous procedure, perform the following steps:
1. Disconnect the coaxial cable from the coaxial outlet.
2. Connect a coaxial cable between the coaxial outlet and the single port
on a two-way coaxial splitter.
3. Connect the coaxial cable disconnected in step 1of this procedure to
one of the dual ports on the splitter.
4. Connect a coaxial cable between the Coax port of the Extender and
the other dual port on the splitter.
The final configuration should be similar to the inset in the figure on the
previous page.
Getting to Know the Extender
9