Installation; Installation As A Free-Standing Unit; Installation Under A Continuous Worktop; Models With Half Closed Base Plate (Initial Production Models) - Miele T300 Technical Information

Technical Information
2.0

Installation

T 352 C, T 358 C, T 359 C, T 367 C, T 368 C, T 369 C, T 369 C-2, T 377
C, T 378 C, T 382, T 383 C, T 388 C
2.1

Installation as a Free-Standing Unit

To ensure fault-free operation, the appliance should be installed perfectly
level.
Any unevenness in the floor can be compensated for by adjusting the
screw-in feet at all four corners.
2.2

Installation under a Continuous Worktop

To correctly install the appliance under a continuous worktop, a "building
under" kit is required. Fitting instructions, Part no. 1508041, are included
with the kit.
Building a machine under can slightly increase drying times but does not,
though, affect energy consumption.
2.2.1

Models with Half Closed Base Plate (Initial Production Models)

These models can be built-in under certain conditions. It is essential to
ensure that sufficient air can be taken in at the rear of the machine.
They may be installed next to a washing machine. However, if the
washing machine has a décor panel front then the service panel sealing
strip should not be fitted so that air intake can also take place in this area.
If the dryer is built-in alone, gaps for air intake must total at least 100 cm
The approx. 10mm gap along the machine's lower front edge should
never be reduced or blocked by deep pile carpets, skirting strips or tiles,
etc.
2.2.2

Models with Fully Closed Base Plate

These models can be built-in. It is essential to ensure that sufficient air
can be taken in at the front of the machine.
The approx. 10 mm gap along the machine's lower front edge should
never be reduced or blocked by deep pile carpets, skirting strips or tiles,
etc.
T300 Series Clothes Dryer (Condenser)
16
2
.