Slideout Emergency Retraction - Bedroom - Winnebago SightSeer Owner's Manual

• Use a 3/4" socket and ratchet wrench on the
motor gearbox shaft to crank the room in or
out as needed. Crank both sides of the room
alternately and equally to avoid wedging the
room.
If help is available, a second person (with a
duplicate socket and ratchet) cranking the
other end simultaneously will greatly speed
up the process.
• Crank the room until it is just "snugged up."
Do not overcrank or you could damage the
gear assembly.
• While maintaining pressure on ratchet
wrenches, re-engage the motor brake by
moving lever clockwise slightly (to right
when facing end of motor).
• Reconnect motor power lead to wiring
harness.
• Fasten slideout room travel latching device (if
equipped) inside the coach before driving the
vehicle.
• See your dealer for service of the slideout
mechanism before using again.
Further Information
See the Slideout Room operating guide
included in your InfoCase for further instructions
and troubleshooting information.
SLIDEOUT EMERGENCY
RETRACTION - BEDROOM
-If Equipped
Crank-In Procedure
If the slideout mechanism is malfunctioning
and the room will not retract using the interior
control switch, you may need to access the
motor/gear assembly and manually crank the
room in to the travel position.
If your coach is equipped with this style of
slideout mechanism (located beneath the rear
bed), slideout manufacturer-supplied tools will
be provided (typically located in the front
passenger side compartment). This tool kit
includes a ratchet wrench, a hex-end shaft, and an
extension shaft.
SLIDEOUT ROOMS AND LEVELING
Manual Slideout Retraction Tool Kit
-Typical Installation
NOTE: The ratchet wrench may be packaged in
the InfoCase.
1. Locate the small, round access hole in the bed
base at the foot of the bed.
2. Attach the shaft extension to hex-end shaft
and place the ratchet wrench onto the hex end
shaft, then insert into the hole in the bed base
as shown.
3. The slotted end of the tool must engage with
the pin in the endshaft on the slideout gear
assembly. See arrow in close-up detail.
SECTION 10 –
10-9