Front Service Access; Engine Access - Interior - Winnebago SightSeer Owner's Manual

SECTION 3 –
DRIVING YOUR MOTOR HOME

FRONT SERVICE ACCESS

(HOOD)
The hood panel can be opened for access to
service items such as:
• Windshield Washer Fluid Reservoir
• Brake Fluid Reservoir
• Generator Oil Dipstick
Release the hood by lifting UP on the Hood
Latches (located on each side of interior hood),
then pull the hood panel outward and raise into
the open position.
• Lift UP the Hood Latches on each side of
interior hood and raise to open position
Front Hood Latch
3-10
To close, pull hood down and push in with
palms of hands on sides to secure latches. You
will hear the hood latches "click" when engaged
in the locked position.
ENGINE ACCESS – INTERIOR
Front Engine Cover
• To remove the engine cover, insert the
supplied hex wrench into the hole in the top
center or the front edge of the engine cover
(depending on model).
Turn the hex wrench to the left (counter-
clockwise) to unlatch.
Insert hex wrench into the hole on the
top center of the engine cover (as
shown) or the front edge of engine
cover to unlatch
-Typical View
NOTE: On some models there may also be
screws to remove at the lower front
corners. See following photo.