Factory Defaults; Backup & Restore - TP-Link TL-WR740N User Manual

use. However, when experiencing problems caused by the Router rather than the configuration,
you can try to upgrade the firmware.
2) When you upgrade the Router's firmware, you may lose its current configurations, so before
upgrading the firmware please write down some of your customized settings to avoid losing
important settings.
3) Do not turn off the Router or press the Reset button while the firmware is being upgraded.
Loss of power during the upgrade could damage the Router.
4) The firmware version must correspond to the hardware.
5) The upgrade process takes a few moments and the Router restarts automatically when the
upgrade is complete.

4.18.4 Factory Defaults

Choose menu "System Tools → Factory Defaults", and then and you can restore the
configurations of the Router to factory defaults on the following screen
Click the Restore button to reset all configuration settings to their default values.
The default User Name: admin
•
The default Password: admin
•
The default IP Address: 192.168.0.1
•
The default Subnet Mask: 255.255.255.0
•

Note:
All changed settings will be lost when defaults are restored.
4.18.5 Backup & Restore
Choose menu "System Tools → Backup & Restore", and then you can save the current
configuration of the Router as a backup file and restore the configuration via a backup file as
shown in Figure 4-94.
TL-WR740N/TL-WR741ND
Figure 4-93 Restore Factory Default
Figure 4-94 Backup & Restore Configuration
92
150Mbps Wireless N Router