Table of Contents
Advertisement
Honeywell
Exposure Value:
Exposure value is AE target value. This value is to adjust the integration, analog gain and
digital gain to achieve the target brightness value (Exposure Value).
This value is dependent to "Auto Exposure" only.
Color Level:
Large value will be colorful.
Hue:
Change the value will result to color tuning.
Brightness:
Large value will brighten camera.
Contrast:
Large value will contrast camera heavily.
Sharpness:
Large value will sharpen camera.
Local video output:
Enable or disable video signal of BNC connector. It's very useful to check view angle or
focus during camera installation. However, disable this function will save power a lot.
Suggest to disabling it after camera installed well.
ICR:
Use built-in photo sensor or manual to control ICR.
In case user selects manual mode, there are 4 modes: Night (On), Day (Off), Auto or
Schedule to control built-in IR LEDs. This function is very useful under low illumination
environment even 0 Lux.
In case the Auto mode is selected, user needs to specify 3 parameters in advance:
Night Mode Threshold (0~10000): this value set the threshold to turn on IR LED. It should be
lower or equal to Day Mode Threshold.
Day Mode Threshold (0~10000): this value set the threshold to turn off IR LED. It should be
higher or equal to Night Mode Threshold.
Delay Time: The delay time between LED ON/OFF switching.
Note that Current Value is the current luminance from the captured video. It's a useful
reference to set LED ON/OFF Threshold.
3D De-Noise:
This function can remove or lower unwanted noise and preserve fine details and edges as
possible.
39
Advertisement
Table of Contents
