Table of Contents
Advertisement
Connections
Connector board
6
The Network Camera also provides composite video output. The video output function is
only for easy installation to check view angle and focus. The output is not a Mega-pixel
resolution. Furthermore, the video output is off by default. To turn on video, please refer to
Setting\Camera\Picture chapter.
Note that to cabling this camera by type of connector board, firstly, user must remove the
attached "connector cable" from wafer 1~ 6 shown as below:
1.
RJ45 LAN socket:
The LAN socket is a RJ-45 connector for connections to 10Base-T Ethernet, 100Base-TX, or
1000Base-TX Ethernet cabling. This Ethernet port built N-Way protocol can detect or
negotiate the transmission speed of the network automatically. Please use Category 5 or
better cable to connect the Network Camera to an Ethernet network switch or hub.
In the LAN socket, there are two LEDs embedded:
Advertisement
Table of Contents
