Table of Contents
Advertisement
Connections
8
The output power is 12VDC. This is used to support DI/DO devices. The output power is
12VDC/50mA maximum.
DI/GND/DO/RS485
Interface of Digital input/output and RS485
a)
AC24V Block
b)
Factory Default Reset
This button is used to restore the all factory default settings. Sometimes restarting the device
will make the system back to a normal state. However, if the system still got problems after
restart, user can restore the factory default settings and configure it again.
3.
Restore the device
i)
Press the button down continuously.
ii)
Hold the button at least 5 seconds and release it. Then the device has been
restored to default settings and reboot again.
Note: Restoring the factory default setting will lose the all previous settings included IP
address forever. User needs to run the IP Wizard II program to search the device and
configure it to let the device work properly again.
4.
Micro SD Card Slot
User can insert a micro SD card into this slot for recording.
In case, you want to use the attached cable to connect this camera again, please check and
plug the cable to wafer 1~6 properly and carefully.
Advertisement
Table of Contents
