Table of Contents
Advertisement
GENERAL INSTALLATION DATA
This equipment is designed and sold for commercial use only by personnel trained and experienced
in its operation and is not sold for consumer use in and around the home nor for use directly by the
general public in food service locations.
CAUTION
Before using your new equipment, read and understand all the instructions & labels associated with
the unit prior to putting it into operation. Make sure all people associated with its use understand the
units operation & safety before they use the unit.
INSPECTION & ASSEMBLY
All shipping containers should be checked for freight damage both visible and concealed. This
unit has been tested and carefully packaged to insure delivery of your unit in perfect condition. If
equipment is received in damaged condition, either apparent or concealed, a claim must be made
with the delivering carrier.
Concealed damage or loss - if damage or loss is not apparent until after equipment is unpacked, a
request for inspection of concealed damage must be made with carrier within 15 days. Be certain
to retain all contents plus external and internal packaging materials for inspection. The carrier will
make an inspection and will supply necessary claim forms.
UN CRATING AND INSPECTING
Unpack the unit and components from the shipping container. Remove all visible packing material.
If damage is discovered, file a claim immediately with the carrier that handled the shipment. DO
NOT operate the unit if it was damaged during shipping.
The following should be included: Holman Conveyor Sandwich Toaster, Stainless Steel Unload Tray,
(four) 4 Stainless Steel Legs, extra Motor, and Magnetic Bake Aid w/Bracket.
ASSEMBLY AND INSTALLATION
The unit was shipped with certain assembly required.
D O NOT PLACE THE UNIT ON ITS SIDE. FAILURE
TO COMPLY MAY RESULT IN DAMAGE TO
EQUIPMENT.
CAUTION
To attach the four 4 legs, with assistance place the unit on
its end as shown (damage to the elements can occur when
the unit is placed on its side) insert the legs by screwing
them into the weld nuts located on the bottom of the unit.
When completed and with help, carefully turn the unit
upright.
N EVER OPERATE UNIT WITHOUT PROPER LEGS
IN PLACE.
CAUTION
Install unit in its operating position. Level unit by adjusting
the feet. Both ends must be at least 6" from any vertical
combustible surface. Allow sufficient space for operating
personnel.
The Unload Tray has a keyhole slot on the tray that will
slide over the two screw heads on the end of the toaster as
shown int the Toaster Components Iluustration.
The crumb tray slides into each end of the toaster under
the conveyor. The slot is formed by two pieces of metal on
each side, under the toaster. They keep the interior of the machine clean
and reflect heat away from the controls and back up to the sandwiches.
A layer of aluminum foil on the tray (check that it does not interfere with the conveyor) will make the
tray more reflective and make cleanup easier.
IL1150
LEG INSTALLATION
Hide quick links:
Advertisement
Table of Contents
