Fujitsu SPARC Enterprise M3000 Product Notes page 33

XCP Issues Fixed in Releases Earlier Than XCP
TABLE 6
ID Description
RTIF1- In XSCF, a host route cannot be set. When you
091109-002 use the setroute(8) command and set the
netmask to 255.255.255.255, it returns an
invalid parameter.
RTIF1- When you use the setnameserver(8)
091109-003 command or the DNS setting of XSCF Web to
register the DNS server or the search path, you
can specify two or more same IP address
values or domain names.
However, when you specify two or more same
IP address values or domain names to delete
all the DNS servers or the search paths which
are same, it returns an invalid parameter.
RTIF1- When you start up a domain from a disk
091109-004 connected to the 8-Gbps fibre channel card
(SE0X7F21F, SE0X7F22F), if you fail to specify
the correct device path, an error log with no
message might be registered.
In the same way, when you start up a domain
from a disk connected to the 8-Gbps fibre
channel card (SE0X7F21F, SE0X7F22F), even if
the domain cannot be started due to reasons
such as disk failure, the error log might not be
registered.
1093
(Continued)
Workaround
To set a host route, do not specify the netmask
(-m option).
To delete all the DNS servers or the search
paths which are same, specify just one
corresponding address or domain name.
In doing so, all the DNS servers or the search
paths which are same will be deleted. Register
the data again as needed.
No workaround is available.
Information About Software 23