Fujitsu SPARC Enterprise M3000 Product Notes page 30

XCP Issues Fixed in Releases Earlier Than XCP
TABLE 6
ID Description
RTIF1- The network configuration on the XSCF Web
081006-005 does not support the function equivalent to the
setnetwork -r command. And when you
specified localhost or localdomain to the host
name or the domain name, the error message
"SessionID has expired" appears.
RTIF1- The panic log on the XSCF Web might not be
081006-006 displayed from the top of the message.
RTIF1- The password(8) command indicates that the
081006-007 [user] operand is optional but will fail if a
[user] operand is not included when other
options are specified.
RTIF1- SNMP trap host configuration changes are not
081006-011 valid until setsnmp disable and setsnmp
enable.
RTIF1- Power failure at the commercial AC supply
081016-001 connector to the UPS does not send
notification/send trap.
RTIF1- In Internet Explorer 6 or 7, clicking on the
081016-003 [Reset] button then the [OK] button from the
Settings->Audit->Add Policy poupup screen
will log the user out with message:
Error
Session Error
Session ID has been expired
RTIF1- When the timezone other than three characters
081030-002 has been set, the error logs cannot be
displayed on XSCF Web "Error Log" page.
In addition, XSCF Web "Panic Log" and "IPL
Message Log" pages display the date on the
table with "---".
RTIF1- The monitor message log might not be
081104-001 registered when a PCI slot error detected.
RTIF1- The domain console may display this message:
090108-001
ipsec_check_inbound_policy: Policy
Failure for the incoming packet
(not secure)
20 SPARC Enterprise M3000 Server Product Notes for XCP Version 1093 • July 2010
1093
(Continued)
Workaround
Use the setnetwork -r command on the
XSCF shell.
When the output is insufficient, execute the
showlogs panic command on the XSCF shell.
No workaround is available.
Specify the user operand to execute the
password(8) command when you specify
other options.
Modify the SNMP setting:
XSCF> setsnmp disable
XSCF> setsnmp enable
No workaround is available.
Log back into the browser interface and use
the backspace key to clear text in the 'User'
text box of the popup screen instead of using
the Reset button.
Use the showlogs(8) command on the XSCF
shell.
No workaround is available.
Use the showlogs error command or the
fmdump command to check the fault
information of PCI slot.
This message can be safely ignored.