Table of Contents
Advertisement
RedPlate BlackVerbDuo Operations Guide
Gain Control – Bypasses the section when rotated to zero, this control sets the amount of
signal for the first gain stage of the section. Low settings are smoother and higher settings are
more aggressive.
Drive Control – Sets the amount of distortion by controlling the level between the 2 gain
stages of the section.
Level Control – Sets the output volume of the section. Higher settings are "bigger" and more 3
dimensional.
The BODY Drive section can also add character to the clean tone. The section's range of effect
can be just a hint of early break up to full on aggressive distortion.
Gain Control – Bypasses the section when rotated to zero, this control sets the amount of
signal for the first gain stage of the section. Low settings are smoother and higher settings are
more aggressive.
Drive Control – Sets the amount of distortion by controlling the level between the 2 gain
stages of the section. Pull this control to shift into more gain and girth for the distortion.
Level Control – Sets the output volume of the section. Higher settings are "bigger" and more 3
dimensional. Pull this control to engage a high frequency roll off.
Reverb Control - Sets the amount of reverberation effect, takes the reverb out of circuit when
rotated to zero (there will be a slight volume and tone change).
Presence Control – The presence circuit uses global negative feedback to remove low
frequencies which frees up bandwidth for more midrange and highs. Think of it as a tone control to
balance the relationship between highs and lows, especially when the amplifier is naturally
BODY DRIVE SECTION
MASTER SECTION
3
Advertisement
Table of Contents
