Other Features; Power On/Off Procedure - RedPlate BlackVerbDue Operation Manual

RedPlate BlackVerbDuo Operations Guide
SEND and RETURN Jacks – The send jack connects to the input of an external effects device
and the return jack connects to the output of an external effects device. The return jack interrupts
the signal path so the external effects unit must mix the wet and dry signals.
Footswitch Jack - This is a standard 180 degree 5 pin DIN jack for footswitch connection. If a
replacement cable is needed, make sure all 5 wires are supported. The pinout is conveniently
located on the rear panel for use with automated switcher conversion boxes.
SMOOTH Switch – Employs local negative feedback in the clean preamp for a hint of
compression.
Humbucker / Single coil Switch – Sets the amount of bass gain in the input stage, useful for
matching the amplifier to the guitar type.
The BlackVerbDuo comes complete with a 4 button footswitch and a footswitch cable. The
cable used is a regular MIDI cable and is readily available in any length at most music stores.
TWEED – Midrange Boost feature. When engaged the size of the treble capacitor is increased
to allow for more upper midrange, at the same time it does a lift of the midrange control for
maximum midrange. The effect can be lessened by pulling the front panel Volume control which
eliminates the midrange control lift. The footswitch button does not work when position 6 of the
rotary MODE switch on the front panel is selected because it is a duplicate function.
EDGE – Character Boost feature. When lit, the Drive section of the amplifier is active, not lit,
means the section is bypassed. The footswitch button does not work when the front panel EDGE
Gain control is rotated to zero because it is a duplicate function.
BOOST – Girth Boost feature. When lit, adds volume and tone by doing a partial tone stack lift.
The footswitch button does not have any affect when the front panel Bass control is rotated to zero
because it is partially a duplicate function.
BODY – Overdrive Section. When lit, the Body section of the amplifier is active, not lit, means
the section is bypassed. The footswitch button does not work when the front panel BODY Gain
control is rotated to zero because it is a duplicate function.
THE EDGE AND BODY SECTIONS CAN BOTH BE ENABLED FOR EVEN MORE GAIN.

OTHER FEATURES

FOOTSWITCH

POWER ON/OFF PROCEDURE

5