Master Section; Rear Panel Section - RedPlate MagicDust Operation Manual

RedPlate MagicDust Operations Guide
Level Control – Sets the output volume of the section. Higher settings are "bigger" and more 3
dimensional.
Treble Control - Adjusts highs (also upper midrange when pulled for a "MidBoost" effect).
Middle Control – Controls the amount of Midrange frequencies, somewhat interactive with
the Bass Control.
Bass Control – Sets the amount of low end. Can be rotated to zero where it clicks off for a full
tone stack lift.
Presence Control – The presence circuit uses global negative feedback to remove low
frequencies which frees up bandwidth for more midrange and highs. Think of it as a tone control to
balance the relationship between highs and lows, especially when the amplifier is naturally
producing increased low end at louder volumes. The control clicks off when rotated to zero for no
presence.
Master Volume – This is an active control and actually adds gain at the higher settings. The
cleanest tones are achieved at settings below 7.
Domestic (USA):
Rear Panel Export:

MASTER SECTION

REAR PANEL SECTION

4