Connecting The Macintosh To The Network; With 10Baset Cabling - Asante MacCon Family Ethernet Network Cards for the Macintosh Installation Manual

9
Place the motherboard (with the MacCon+ controller card
riding piggyback on it) back into the guides on the left
side of the chassis.
10
Reconnect the power supply and the disk drive cable on
the component side of the motherboard.
11
Plug the ribbon cable into the controller card's receptacle.
Make sure the white dot on the ribbon cable aligns with
the white dot on the connector. (The blue wire is pin 1 on
both ends of the cable.)
12
Close the Macintosh SE:
— Place the Macintosh SE face down.
— Fit the aluminum shield over the external device con-
nectors and around the bottom and sides of the moth-
erboard.
— Fit the plastic case over the chassis and snap the case in-
to place. Screw the case shut.

Connecting the Macintosh to the Network

To connect the Macintosh to the Ethernet cable, perform the follow-
ing steps:

With 10BaseT cabling

1
Plug the RJ-45 connector on one end of the 10BaseT cable
into the RJ-45 jack on the card. The RJ-45 connector's plastic
tab snaps locked into the jack.
2
Plug the other end of the cable directly into a hub or plug
it into a 10BaseT wall jack. A green LED (link integrity)
light indicates a good connection to the hub.
Note: Asanté offers a full range of intelligent and non-in-
telligent 10BaseT-compliant hubs.
With thin Ethernet cabling
!
Check with your network administrator before you discon-
nect the Ethernet cable. Network users must be warned if
you are bringing down the network.
2-24
Caution
Installing Asanté MacCon Cards