Video Options; Setting The Slot Address For Two Cards - Asante MacCon Family Ethernet Network Cards for the Macintosh Installation Manual

Video Options

Even though the Macintosh IIsi has only one expansion slot, you can
install both a MacCon3 IIsi card and the Radius video card. An exter-
nal interface device is not needed and high performance is main-
tained. The following table shows which MacCon cards you can
install with the Radius and SuperMac video cards and which ports are
available for connecting to the Ethernet.
MacCon compatibility with third-party video cards
Video card
Radius Pivot IIsi
SuperMac
Spectrum/8 24 PDQ
Spectrum/8 24 PDQ si

Setting the Slot Address for Two Cards

Since the two cards cannot use the same slot address, change the slot
address for the Asanté card by setting the JP1 and JP2 jumpers on the
larger controller card. If you keep the default slot address of 9 for the
video card, you can set the Asanté card address to A, B, or E, as
shown in the following table.
JP1 and JP2
jumpers
2-14
Asanté card
MacCon3 IIsi
FriendlyNet IIsi
Address Set
9
JP2
E
JP1
Ethernet ports available
RJ-45 and BNC
AAUI with FriendlyNet
Media Adapter for
10BaseT/Thin/thick
Address Set
ON
JP2
ON
JP1
ON
JP2
OFF
JP1
Installing Asanté MacCon Cards
A
JP2
JP1
JP2
B
JP1
OFF
ON
OFF
OFF