Misc Tab - Roland M-5000 Reference Manual

You perform the following operations in the parameter area.
LO TYPE
HPF/LPF HPF/LPF center frequency
HPF/LPF ON
Turns HPF/LPF on/off.
FREQ Center frequency
Q Sharpness of the frequency-response curve
TYPE
Displays the Filter Type Selection popover.
GAIN Gain
Turns the respective band on/off.
ON
Pressing and holding this resets the respective
band.
Memo
The level detection points for INPUT meter and OUTPUT meter
are as follows.
HPF INS
DYN 1
LPF A
Filter Type Selection Popover
PEAK Peaking
LSV Low shelving
HSV High shelving
HPF High-pass filter (-6 dB/oct)
HPF2 High-pass filter (-12 dB/oct)
LPF Low-pass filter (-6 dB/oct)
LPF2 Low-pass filter (-12 dB/oct)
BPF
Bandpass filter
NOTCH Notch filter
LSV2 Low shelving with controllable Q
HSV2 High shelving with controllable Q
LM TYPE HM TYPE
INPUT OUTPUT
DYN/EQ
METER METER
or
(PRE EQ) (POST EQ)
EQ/DYN
4-BAND
DYN 2
EQ

MISC Tab

In the MISC tab, you make a variety of settings, such as Delay, Direct
Out, Channel Safe, Solo, and Insert.
HI TYPE
DELAY ON
UNITS
SET ALL CH
LINK DELAY
SAFE
DIRECT OUT ON
DIRECT OUT (L/R)
INS
B
POINT
SOLO 1/2
INSERT A/B ON
INSERT A/B (L/R)
DELAY (L/R)
DELAY (L/R) ON
FINE DELAY L/R
DIRECT LEV
DIRECT LEV ON
CH EDIT Window
Turns Delay on/off.
Selects from among the following as the unit for
delay time.
5 ms
5 meter
5 feet
5 24fps/25fps/29.97fps/30fps
Makes the unit for delay time on all input
channels the same as the selection made using
<UNITS>.
Makes the delay times for all stereo channels,
stereo buses, and surround buses identical.
When on, the channel is excluded from scene
recall.
Turns Direct Out on/off.
Selects the Direct Out output connector.
Selects from among the following as the send
point for Direct Out.
5 TOP OF CH
5 PRE EQ
5 PRE FADER
5 POST FADER
SOLO selection
5 SOLO 1
5 SOLO 2
5 SOLO 1+2
Turns Channel Insert on/off.
Selects the effect/GEQ/external effect to insert on
the channel.
Delay time
Turns Delay on/off.
Fine-tuning of delay time
Direct Out level
Turns Direct Out on/off.
107