Table of Contents
Advertisement
Panic Mode
Note: Panic mode can only be activated if the horn has been adequately configured by the
installer.
In an emergency situation, you can activate panic mode by pressing and holding the
until the horn starts honking. If the vehicle is under a remote start, the engine will shutdown
automatically before setting off the horn. You can stop the horn by pressing:
(this will lock your doors and deactivate panic mode), or
(this will unlock your doors and deactivate panic mode).
Furthermore, the panic mode can be stopped by activating Valet Mode (page- 8)
* Panic Mode will automatically shut down after 30 sec.
Quick Lockout
(Also called Secure Panic.) For fast protection in emergency situations, the system will LOCK all
doors when you press the brake pedal while you hear the sound signal. (Quick Lockout is only
available when panic mode has been triggered.)
Cold Weather Mode
If the vehicle has a manual transmission, Ready mode (page-6) should be set before entering
Cold Weather Mode. When Cold Weather Mode is active, the engine starts every 2 hours and runs
for 3 minutes (or for 8 or 20 minutes with diesel engines). Cold Weather Mode automatically ends
after 24 hours (or 12 starts).
To enter Cold Weather Mode:
1.
Press and release the
2.
The
button on the transmitter will light up.
3.
While the
pause, then beeps twice.
4.
Release the
To exit Cold Weather Mode, do any one of the following actions:
1.
Open the hood.
2.
Start the engine by remote.
3.
Turn the ignition key to the IGNITION ON (RUN) position.
4.
Press and release the
a.
b.
c.
To verify whether the system is in Cold Weather Mode, do any of the following:
•
Press the brake pedal: If the vehicle is in cold weather mode, the parking lights will stay
on while the pedal is pressed. (automatic transmissions only)
•
Do the vehicle status request feature (page-14)
Extended Run Time
While the vehicle is running under a remote start, press and hold the
beeps 3 times. This will reset the run time counter to zero and restart the run time cycle from the
beginning.
User Guide
TM
button is still lit, press and hold the
button. It's LED will flash quickly.
The
button on the transmitter will light up.
While the
button is still lit, press and hold the
beeps once, pause, then beeps once again.
Release the
button. Its LED will flash quickly.
button.
button.
button until the remote beeps once,
button until the remote
button until the remote
button
P.9
Hide quick links:
Advertisement
Table of Contents
