Table of Contents
Advertisement
I. Electrical Safety Information:
A) Compliance is required with respect to the voltage, frequency, and current requirements
B) There are no operator serviceable parts inside this equipment. There are hazardous
C) Contact a qualified electrician or the manufacturer if there are questions about the
II. Emissions and Immunity Information
A) Notice to Users in the United States: This equipment has been tested and found to
B) Notice to Users in Canada: This equipment complies with the Class B limits for radio
C) Notice to Users in the European Union: Use only the provided power cords and
This Information Technology Equipment (ITE) is required to have a CE Mark on the
manufacturer's label which means that the equipment has been tested to the following
Directives and Standards: This equipment has been tested to the requirements for the CE
Mark as required by EMC Directive 2004/108/EC indicated in European Standard
EN 55022 Class B and the Low Voltage Directive 2006/95/EC as indicated in European
Standard EN 60950.
36
R
indicated on the manufacturer's label. Connection to a different power source than those
specified herein will likely result in improper operation, damage to the equipment or
pose a fire hazard if the limitations are not followed.
voltages generated by this equipment which constitute a safety hazard. Service should be
provided only by a qualified service technician.
installation prior to connecting the equipment to mains power.
comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy, and if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
noise emissions from digital apparatus as established by the Radio Interference
Regulations of Industrie Canada.
interconnecting cabling provided with the equipment. Substitution of provided cords and
cabling may compromise electrical safety or CE Mark Certification for emissions or
immunity as required by the following standards:
EGULATORY
I
NFORMATION
Advertisement
Table of Contents
