Table of Contents
Advertisement
SECTION 10
SLIDEOUT
•
Crank the room in until it is just 'snugged up'.
Do not overcrank or you could damage the
gear assembly.
•
Fasten the travel strap before driving the
vehicle to your dealer for service of the
slideout mechanism.
•
See your dealer for service of the slideout
system before using again.
Further Information
See the Slideout Room operating guide
included in your Owner's InfoCase for further
instructions and troubleshooting information.
Bedroom Slideout Emergency
Retraction - Model 329B
1. Locate the tools in the right front side storage
compartment - a ratchet wrench, a hex-end
shaft and an extension shaft. (The ratchet
wrench may be packaged in the Owner
InfoCase.)
2. Locate the small, round access hole in the
bed base at the foot of the bed.
10-6
3. Attach the shaft extension to hex-end shaft
and place the ratchet wrench onto the hex end
shaft, then insert into the hole in the bed base
as shown.
4. The slotted end of the tool must engage with
the pin in the endshaft on the slideout gear
assembly. See arrow in close-up detail.
5. Crank the ratchet wrench clockwise (to the
right) to retract the room. The tool will extend
nearly a foot out of the bed base at first, but
will be drawn into the bed base as the room is
retracted. This is a slow process that will take
some time and quite a few turns of the wrench.
6. As the room retracts, the bed base will move
away from the gear endshaft, which will
eventually cause the tool to lose of contact
with the shaft. When this happens you must
raise the bed, remove the access cover to
access the gear endshaft, and continue using
the wrench and hex shaft only as shown.
Advertisement
Table of Contents
