Picture Frame/Computer Communications - Kodak EASYSHARE W820 Extended User Manual

Troubleshooting and support
Resetting the clock after losing power
If you turn off the power on the frame or otherwise lose power for half a day or more,
the clock time returns to the factory setting and the automatic on/off times, if set, are
disabled.
I When you turn the frame back on, the set time screen appears on the frame.
I Slide to set the hour. Tap the left/right arrows to highlight the previous or next
setting (hour and minutes), then slide to adjust the setting.
Tap OK.
I
The Home screen appears. The time is reset and the automatic on/off times (if set) are
re-enabled. It is not necessary to reset the on/off times.
NOTE: If you exit the set time screen without setting the time, you can manually reset the clock and
re-enable the automatic on/off times (see

Picture frame/computer communications

If...
Cannot copy pictures to my
computer.
Cannot see my frame as a
removable drive.
Cannot copy pictures from
KODAK EASYSHARE
Software.
60
page 51). It is not necessary to reset the on/off times.
Try one or more of the following
I
Make sure your frame and computer are on.
I
Make sure to install the software that was packaged with
your frame (see
frame and computer using the EASYSHARE Digital Display
Software (page
I
Make sure the USB cable is securely connected
I
Make sure the power button on the frame is On
I
Make sure your frame and computer are on.
I
Make sure the USB cable is securely connected
I
Make sure to install the software that was packaged with
your frame (page
I
From My Collection in EASYSHARE Software, make sure the
pictures are in the Picture Tray.
page 9) and copy pictures between your
44).
9).
www.kodak.com/go/support
(page 24).
(page ii).
(page 24).