Harman Stove Company Accentra Owner's Manual page 10

IMPORTANT NOTE:
shipped bolted to the skid through two holes in the cast
base plate. If these holes are not used to lag the unit to
the floor these holes must be filled with the 3/8" x 1/2"
hex head bolts provided. (See tag on bolt bag provided.)
Adjustment of the rubber pad leveling
feet
The Accentra is provided with 4 rubber pad feet. These
feet will raise the bottom edge of the cast base plate off
the floor surface. This will insure that any vibrations
caused by motors and other moving parts will not be
transferred by direct contact. These rubber pads have a
threaded stud that extends through the base plate. The
top of the threaded stud has a screwdriver slot.
Therefore, the unit can be leveled from above inside the
unit. The front two are in the right and left front corners
of the firebox. NOTE: The door will need to be partically
closed to access the right leveling pad stud due to the
door hinge.
The rear two studs are to the right and left of
the distribution blower. They are somewhat difficult to
reach, therefore, it is suggested that the rear two pads
be adjusted by tilting the unit slightly forward. Adjust
the pads with your fingers and tilt unit back for fit. Then
adjust the front pads for the final clearance. (The use of
the rubber pads is not necessary if not desired.)
Installation
The Accentra unit is
Fig. 14
Skid bolt down holes/floor lag down holes
Fig. 15
Leveling/vibration dampening feet