Illuminated Approach - If Equipped; To Lock The Doors And Liftgate; Flash Lights With Remote Key Lock/Unlock; Battery Replacement - Jeep Compass 2015 Operating Information Manual

3. Test the feature while outside of the vehicle
by pushing the LOCK/UNLOCK buttons on
the RKE transmitter with the ignition switch
in the LOCK position and the key removed.
4. Repeat these steps if you want to return this
feature to its previous setting.
NOTE:
Pushing the LOCK button on the RKE trans-
mitter while you are inside the vehicle will
activate the Vehicle Security Alarm. Opening
a door with the Vehicle Security Alarm acti-
vated will cause the alarm to sound. Push
the UNLOCK button to deactivate the Ve-
hicle Security Alarm.
Illuminated Approach — If Equipped
This feature activates the headlights for up to 90
seconds when the doors are unlocked with the
RKE transmitter. The time for this feature is
programmable on vehicles equipped with the
EVIC. Refer to "Electronic Vehicle Information
Center (EVIC)/Personal Settings (Customer-
Programmable Features)" in "Understanding
Your Instrument Panel" for further information.
16

To Lock The Doors And Liftgate

Push and release the LOCK button on the RKE
transmitter to lock all doors and liftgate. The turn
signal lights will flash to acknowledge the sig-
nal.
Flash Lights With Remote Key
Lock/Unlock
This feature will cause the turn signal lights to
flash when the doors are locked or unlocked
with the RKE transmitter. This feature can be
turned on or turned off. To change the current
setting, proceed as follows:
• For vehicles equipped with the EVIC, refer to
"Electronic Vehicle Information
(EVIC)/Personal Settings
Programmable Features)" in "Understanding
Your Instrument Panel" for further informa-
tion.
• For vehicles not equipped with the EVIC,
perform the following steps:
1. Push and hold the UNLOCK button on a
programmed RKE transmitter for at least 4
seconds, but no longer than 10 seconds.
Then, push and hold the LOCK button while
still holding the UNLOCK button.
2. Release both buttons at the same time.
3. Test the feature while outside of the vehicle
by pushing the LOCK/UNLOCK buttons on
the RKE transmitter with the ignition switch
in the LOCK position and the key removed.
4. Repeat these steps if you want to return this
feature to its previous setting.
NOTE:
Pushing the LOCK button on the RKE trans-
mitter while you are in the vehicle will acti-
Center
vate the Vehicle Security Alarm. Opening a
(Customer-
door with the Vehicle Security Alarm acti-
vated will cause the alarm to sound. Push
the UNLOCK button to deactivate the Ve-
hicle Security Alarm.

Battery Replacement

The recommended replacement battery is
CR2032.