EPS Bio Technology EasyMax User Manual page 4

Chapter 1: Understanding Your Meter
The EasyMax N Blood Glucose Meter
EasyMax Test Strip
A. Blood Collection Area
B. Reaction Area
C. Hand Hold Area
D. Strip Insert Direction
E. Electrode
Setting the Time and Date - First Time Use
2. The time and date appear
1. Press and hold the "S"
on the display. The year
button until turning the
flashes at the center of the
meter on. Press "S"
display.
button and release to
enter setting mode.
M Button
To turn on the meter or read records.
S Button
To turn on the meter or go into Setting Mode.
Strip Slot
To insert test strip or check strip.
3. Press "M" button to adjust
the year. Press and hold
"M" button to scroll faster.
Page 5
4. Press and release "S" 5. Repeat step 3 and 4 to
button to set the year. set the date, hour and
The month will then minute. The flashing field
flash. is the one you are setting.
Note: The unit of Blood Glucose Meter is set at mg/dL
without any modification function.
Memory, Storing Test Results
This meter stores a maximum of 480 test results with the time and date of the test. You can review
them at any time. When the memory is full, the oldest result is dropped as the newest is added, so it
is very important to have the correct time and date set in the meter.
Note:
1. The memory is not lost when you replace the battery. The time and date will remain correct.
2. Once 480 results are in memory, adding a new result causes the oldest one to be deleted.
3. Control Solution values will be included in the memory and averages. Refer to the section
"Viewing & Deleting Test Results" to delete the control solution values before averaging test
results.
Viewing & Deleting Results
4. To delete a test result,
1. Press and hold the "S"
Press and hold "M" for
button until turning the
more than 3 seconds. The
meter on.
display will show "dEL".
2. Press the "M" button to
5. Continue pressing "M"
view the last test result.
without releasing, the
3. Press "S" to view the
currently viewed result
previous results in order
will be erased.
from the most recent to
the oldest.
6. Press the "S" button to confirm
the setting. The display will
show "SCL" and the unit of
measurement. Press the "S"
button again, to go to the screen
shown in Step 1. Press and hold
"S" for more than 3 seconds, and
the meter will turn off.
6. Press "M" and release to
review the average results
for the last seven days.
7. Press "S" to view averages
for 14 or 28 days.
8. Press "M" to close the
memory mode.
Page 6