Calculated Industries ProjectCalc Plus MX 8528 User Manual page 7

tiles based on various Standard Tile Sizes (see "Default/
Standard Values for Materials" ). Note: In the calculation,
the corresponding tile size will show in the upper right of
the display. Tile sizes are labeled in millimetres, not
square millimetres (or sq. metres). In other words, a
"100mm tile" is really 100mm x 100mm or a 10,000
square-mm (0.01 sq. m) size.
Note: Calculation does not account for grout width, so
you will need to adjust for this.
Also note that this key cannot be customized; you must
use Custom Tile Keys Ç 6 if you are using other than
the stored tile sizes.
F
Calculates carpet length required in metres based on
entered area and Standard Carpet Roll Sizes (see
"Default/Standard Values for Materials" ). Repeated presses
of F will scroll between standard roll sizes. Note: this
key cannot be customized.
b
Calculates the number of standard "face" bricks and
"paver" bricks based on an entered length, area or vol-
ume and the Standard Brick Sizes. Repeated presses of
b will swap back and forth between the number of
"face" and "paver" bricks, and the entered dimensional
value. Note: this key cannot be customized.
Ç 4 — 8 x 4 Sheets
Calculates number of plywood/drywall sheets based on an
entered linear distance or area and Standard Sheet Sizes
(see "Default/Standard Values for Materials" ). Note: this
key cannot be customized
Ç 5 — Bulk Bags
Calculates number of bags of gravel or sand based on an
entered volume and a stored Bulk Bag Size.
s 5 — Stores Bulk Bag Size
Stores a new Bag Size. Note: You must enter or find the
bag's cubic volume first. Use length x width x height, then
s 5. To recall this setting, press r 5.
®
ProjectCalc Plus MX User's Guide — 5