Remote Control Functions - Siemens easyTek User Manual

Pairing may take several seconds.
The green LED indicates the pairing status:
Pairing status for hearing instruments
flashing, then on for 5 seconds, then off
➧
Pairing is finished. An acoustic signal is played.
You can now use easyTek.
flashing for 10 minutes, then off
➧
Hearing instruments could not be paired.
Refer to section "Troubleshooting".
When pairing is finished, easyTek is ready...
... for remote control functions.
■
Refer to section "Remote control functions".
... for pairing Bluetooth devices as long as
■
the blue LED is flashing
Refer to section "Pairing Bluetooth devices".
If you want to pair Bluetooth devices not now
but later on, press .
12
.

Remote control functions

easyTek is a remote control for your hearing instruments.
The following functions are available:
Function Description
Volume
or
Press shortly to adjust step by step.
Press and hold until desired volume is
reached.
Hearing program
short press
➧
Switches to the next hearing
program.
This function is not available during
audio streaming.
Turn on/off
and
➧
(standby)
Turns your hearing instruments
on or off.
Further information:
If you are wearing two hearing instruments, both
■
instruments are adjusted at the same time.
After turning the hearing instruments on with easyTek,
■
the previously used volume and hearing program are
set.
You can quickly turn the hearing instruments back
on by pressing the multi-function button shortly.
long press (2 seconds)
13