Siemens easyTek User Manual page 26

This device complies with Part 15 of the FCC Rules and
with RSS-210 of Industry Canada.
Operation is subject to the following conditions:
this device may not cause harmful interference, and
■
this device must accept any interference received,
■
including interference that may cause undesired
operation.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
■
Increase the separation between the equipment and
■
receiver.
48
Connect the equipment to an outlet on a circuit
■
different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV
■
technician for help.
Made for iPhone, iPad
"Made for iPhone" and "Made for iPad" mean that the
device has been designed to connect specifically to
iPhone or iPad, respectively, and has been certified by the
developer to meet Apple performance standards. Apple
is not responsible for the operation of this device or its
compliance with safety and regulatory standards. Please
note that the use of this accessory with iPhone or iPad
may affect wireless performance.
49