Network Setup - D-Link DCS-932L User Manual

Section 3 - Configuration
This section allows you to configure your network settings.
DHCP:
Select this connection if you have a DHCP server running on your network and
would like a dynamic IP address to be updated to your camera automatically.
Static IP Address:
You may obtain a static or fixed IP address and other network information from
your network administrator for your camera. A static IP address will ease you for
accessing your camera in the future.
• IP Address: The fixed IP address
• Subnet Mask: The default value is "255.255.255.0. " Used to determine if the
destination is the same subnet.
• Default Gateway: The gateway used to forward frames to destinations
in a different subnet. Invalid gateway settings may cause the failure of
transmissions to a different subnet.
PPPoE Settings: If you are using a PPPoE connection, enable it and enter the User Name and
Password for your PPPoE account. You can get this information from your
Internet service provider (ISP).
Primary/ If needed, enter the IP addresses Primary and Secondary domain name servers
Secondary DNS:
you wish to use.
HTTP Port: You may configure a Second HTTP port that will allow you to connect to
the camera via a standard web browser. The port can be set to a number
other than the default TCP ports 80. A corresponding port must be opened
on the router. For example, if the port is changed to 1010, users must type
http://192.168.0.100:1010 instead of only "http://192.168.0.100".
UPnP:
Enable this setting to configure your camera as an UPnP device in the network.
UPnP Port Enable this to allow your camera to use UPnP to configure port forwarding on
Forwarding: your router.
D-Link DCS-932L User Manual

Network Setup

25