Cutting A Hole And Mounting Installation Plate - Toshiba MMK-AP0074MH-E Installation Manual

SMMS High-Wall Type
5.

Cutting a Hole and Mounting Installation Plate

Cutting a hole
In case of installing the refrigerant pipes from the
rear:
1
Decide the hole position for piping at 100
mm from the arrow mark ( ) on the
installation plate and drill a hole with Ø65
mm at a slight downward slant toward
outdoor side.
The centre of the pipe hole is
above the arrow
NOTE
• To drill a wall that contains a metal lath, wire lath
or metal plate, use a pipe hole brim ring sold
separately.
Mounting the installation plate
For installation of the indoor unit, use the paper
pattern in the accessory parts.
Fix the installation plate to the wall with screws to
make the indoor unit fit to the wall.
Hook
170
85
Thread
Pipe hole
Hook
Indoor unit Weight
Pipe hole
23 mm
100 mm
107
127.5
Installation
plate
Hook
Pipe hole
Mounting Screw
– 14 –
When the installation plate is
directly mounted on the wall
1
Securely fit the installation plate onto the
wall by screwing it in the upper and lower
parts to hook up the indoor unit.
2
To mount the installation plate on a
concrete wall with anchor bolts, utilize the
anchor bolt holes as illustrated in the above
figure.
3
Install the installation plate horizontally in
the wall.
CAUTION
To install the installation plate with a mounting
screw, do not use the anchor bolt hole.
Otherwise the unit may fall down and result in
personal injury and property damage.
NO OK NO
GOOD GOOD
5 mm dia. hole
Clip anchor
(local parts)
CAUTION
Failure to firmly install the unit may result in
personal injury and property damage if the unit
falls.
• In case of block, brick, concrete or similar type
walls, make 5 mm dia. holes in the wall.
• Insert clip anchors for appropriate mounting
screws.
NOTE
• Secure four corners and lower parts of the
installation plate with 6 mounting screws to
install it.
Installation Manual
Anchor bolt
Projection
15 mm or less
Mounting screw
4 × 25
EN
14-EN