Glide-Out Grill - Rangemaster Excel 110 G5 Induction User's Manual & Installation Instructions

Fig. 5.2
ArtNo.331-0001Grill pan pulled forwards
Fig. 5.3
ArtNo.331-0003 Grill frame out, no pan
Fig. 5.4
ArtNo.331-0004 Removing the grill frame
Fig. 5.5
ArtNo.331-0005 Removing the grill rail
Fig. 5.6
ArtNo.331-0006 Grill pan plan
Cleaning Burned-on Spills
Make sure that the heat indicator lights are off and that the
hob is cool. Remove the excess burned-on substance with a
single-edged razor scraper. Hold the scraper at an angle of
about 30° to the surface and then scrape off the burned-on
matter (Fig. 5.1).
Once you have removed as much as possible with the scraper,
follow the 'Daily Care' procedure outlined above.
To Remove Metal Rub-off
Sliding pans on the hob – especially aluminium or copper
pans – can leave marks on the surface. These marks often
appear like scratches, but can easily be removed using the
procedure described previously for 'Cleaning Spills'. If the
rub-off marks are especially stubborn, use a cleaning cream
together with the razor scraper, as described in 'Cleaning
Burned-on Spills'.

Glide-out Grill

Before you remove any of the grill parts for cleaning,
n n
make sure that they are cool, or use oven gloves.
The grill pan and trivet should be washed in hot soapy water.
Alternatively, the grill pan can be washed in a dishwasher.
After grilling meats or any foods that soil, leave to soak for a
few minutes immediately after use. Stubborn particles may
be removed from the grid using a nylon brush.
The grill pan can be easily removed for cleaning as follows:
Remove the grill pan support frame by pulling the grill pan
forward (Fig. 5.2).
Lift the grill pan clear of the support frame. The support frame
is held to the side rails by two clips on each side (Fig. 5.3).
For each side, support the side rail with one hand and with
the other hand lift the frame up and out of the side clips
(Fig. 5.4).
For safety's sake, push the side rails back into the grill
chamber.
If you need to remove the side rails to allow cleaning of the
grill chamber, you can unhook them from the grill chamber
sides (Fig. 5.5) and wipe the sides clean with a soft cloth and
mild detergent.
DO NOT put the side runners in a dishwasher.
Once you have finished, hook the side rails back onto the
sides of the chamber. To refit the frame, pull the side rails
forward and, for each side in turn, support the side rail and
press the frame down into the side rails. Replace the grill pan.
When refitting the grill pan, make sure that the wide rim is at
the front (Fig. 5.6).
19