Removing A Blockage - ALDI WorkZone WB 12-2 User Manual

GB IRE
Operation
9. First gently push the On/Off switch to start the cordless drill.
If you push the On/Off switch, the LED work light
poorly lit work areas.
10. Afterwards, push the On/Off switch while applying more pressure.
The rechargeable battery may heat up depending on the load. Let the rechargea-
ble battery cool off meanwhile.
11. Hold the On/Off switch down until you have finished your work.
12. If necessary, change the direction of rotation of the quick-action drill chuck with the
right-handed/left-handed rotation selector to remove the drill bit from the bore hole.
13. Remove the drill bit or the magnetic bit holder and the bits
(see chapter "Removing tools").
14. Push the battery release button and pull the rechargeable battery battery out of
the cordless drill. Store the cordless drill and the accessories properly in the plastic
case.

Removing a blockage

Follow the steps below to remove a blockage:
1. If the cordless drill engages a blockage, release the On/Off switch and pull the drill
bit out of the drill hole.
2. Check whether the blockage is caused by the cordless drill by briefly pushing
the On/Off switch. Do not point the drill bit towards yourself or other persons and
animals.
• If it is not possible to start the cordless drill, follow the instructions in chapter
"Troubleshooting", point 1.
• If the cordless drill is working properly, follow the next steps in this chapter.
3. When screwing, set the torque adjustment ring to a higher torque.
4. Push the On/Off switch all the way down and apply some pressure to the cordless
drill.
5. Take occasional breaks and take the drill bit out of the drill hole so that the drill bit
can cool off.
6. Repeat steps 4 to 5 until the blockage has been removed.
20 20
meister-service@meister-werkzeuge.de
9
will turn on to illuminate
AFTER SALES SUPPORT
GB
IRE
00800 34 99 67 53