Removing A Blockage; Tips And Tricks On How To Work Properly - ALDI Ferrex FABH 20-I1 WU5420403 User Manual

First use

Removing a blockage

If the product locks up, proceed as follows:
1. Immediately let go of the On/Off switch
has locked up.
2. If necessary, pull the drill bit (not included in the package contents) out of the drilling
hole.
3. Check whether the blockage is caused by the product by briefly pushing the On/
Off switch. Do not point the drill bit towards yourself or other persons and animals.
• If the product cannot be started, make sure that the switch (right-hand/
left-hand rotation)
position and the rechargeable battery (not included in the package contents)
is correctly inserted and sufficiently charged. Now try starting the product
again. If the product does not start, please contact the manufacturer's After
Sales Support.
• If the product is running smoothly, go to step 4.
4. Push the On/Off switch all the way down and apply some pressure to the product.
5. Take occasional breaks and, if necessary, take the drill bit out of the drilling hole so
that the drill bit can cool off.
6. Repeat steps 4 to 5 until the blockage has been removed.

Tips and tricks on how to work properly

The information and instructions in this user manual are provided to ensure your
personal safety and the safety of other persons. They are also intended to prevent
damage.
If you follow the tips and tricks provided below, you can complete your work with the
product even more safely and efficiently in a satisfactory manner.
− Please be sure to put down or pick up the product in a switched-off state.
Rotating tools can slide off.
− Use only drill bits that are suitable for the respective material to be machined.
− Do not use dull drill bits.
− Do not start drilling into tiles using the 'Hammer drilling' setting (see chapter
'Setting the mode and direction of rotation'). If you do, the ceramic can shatter.
Drill at low speed. As soon as you have drilled through the hard glaze, you can
switch on the 'Hammer drilling' setting and finish drilling.
− For walls of unknown material or for plaster walls, drill a test hole without the
'hammer drilling' setting. If you want to drill a hole into concrete, the drill will
penetrate only a little or not at all. Plaster can be drilled into without excessive
force.
20
6
5
for the direction of rotation is not in the middle
as soon as you notice that the product