Blood Pressure Monitor Advanced Technology Measures While Inflating Instruction Manual Model Number 1095 ID #08/01 Requires 4 “AAA” Alkaline Batteries YEAR LIMITED WARRANTY ™...
TABLE OF CONTENTS Identification of Parts ....... . 3 Battery Installation/Replacement ......4 Preparing to Use the Monitor -Using the Monitor Attached to the Arm Cuff.
Identification of Parts Release Button Memory Button Battery Cover Air Tube Connector Release Button LCD Display Arm Cuff ON/OFF/START with Air Plug Button Air Plug (to cuff) Air Tube Air Plug (to monitor) 4 “AAA” size Alkaline Batteries...
SmartInflate Technology Thank you for purchasing the Lumiscope™ 1095 Comfort Line Blood Pressure Monitor. A state of the art line of blood pressure monitors that MEASURE ON INFLATION UP TO TWICE AS FAST as traditional monitors, thus eliminating the pain and discomfort com- monly felt with traditional styles.
The 1095 can be used either attached to the cuff or as a table- top monitor with the enclosed airtube attachment. Preparing to Use the Monitor Using the Monitor Attached to the Arm Cuff • Angle the bottom of the monitor against the raised part of the plastic piece on the cuff (fig.
Page 6
NOTE: If the Index line falls within the OK range (indicated along the upper edge of the cuff) this cuff is suitable for your use. If the Index line falls out of the OK range, con- tact the Lumiscope Service Dept. for an Oversize cuff. (model # 109-235) Fig. F 2~3 cm 0.8~1.2 inch...
Measurement • Press the “ON/OFF/START button. • All display symbols will appear for approximately one second before the display returns to “0”. • The unit will automatically start to inflate slowly, measuring your blood pressure. During inflation, the changing values of the cuff pressure will be shown on the display.
Subsequent Measurement When a second measurement needs to be made, the time between two measurements should be at least teb minutes. Automatic Power OFF Function If unit is left on after measurement, an “Automatic Power-OFF Function” turns the power off after approximately one minute. To continue with another measurement press the “ON/OFF/START”...
Description of Display Marks DISPLAY MARK CONDITION/CAUSE Blood pressure could not be measured accurately. Batteries are weak. Device malfunction. CORRECTIVE ACTION Exhaust all air from the cuff. Reapply the cuff properly. Repeat measurement. Replace the batteries. Return to Lumiscope™ Service Department.
Power Source Power Consumption Battery Life Automatic Power-Off Memory Function Dimension Weight Operating Environment Storage Environment 1095 Oscillometric Method Left Upper Arm Soft Cuff 8.66 to12.6in 20 to 280 mmHg Pressure 40 to 180 Pulses/min. Pulse ±3 mmHg Pressure ±5% of reading...
Repair Department. Service of this product by anyone other than Lumiscope™ Repair Department voids warranty. In the event that Lumiscope™ does not abide the terms of this warranty the consumer may seek breach of contract remedies in the New York State Federal courts of law.