Related Manuals for Lumiscope 1098
Summary of Contents for Lumiscope 1098
-
Page 1: Blood Pressure
Blood Pressure Monitor Instruction Manual Model Number 1098 ID # = Requires 2 “AAA” Alkaline Batteries YEAR LIMITED WARRANTY... -
Page 2: Table Of Contents
TABLE OF CONTENTS Identification of Parts ....... . . 3 Battery Installation/Replacement . -
Page 3: Identification Of Parts
Identification of Parts Memory Key ON/OFF Key LCD Display Battery Cover Wrist Cuff 2 "AAA" type battery LCD Display... -
Page 4: Battery Installation/Replacement
Battery Installation/Replacement • To use the unit, you must install batteries. • Open battery cover as illustrated. Install or replace two new batteries, making sure the polarities (+ and -) on the battery match the polarities on the case. • Replace battery cover. •... -
Page 5: Measurement
Measurement NOTE: Unit measures on inflation. • To start the measurement Press the “ON/OFF” switch. • Initial display. • Pumping. • Measuring and Beeping sounds. • Once the blood-pressure measurement has stabi- lized, pressurization is discontinued and the air in the cuff is automatically let out. -
Page 6: Subsequent Measurement
• Blood pressure values and pulse rate are alternately displayed. The unit will continue to display the measurement until power is turned off. • Turn Power off Press the “ON/OFF” switch to turn off. NOTE: To discontinue a measurement for any reason, press the “Power/Start” switch. -
Page 7: Setting The Clock
Setting the Clock Enter the setting mode by pressing and hold- ing the MEMORY key for over three seconds. The display will show a blinking year. Press the ON/OFF key to adjust the year when it is blinking. Then press and release the MEMO- RY key again, the month will apear and blink to be adjusted, then the date, hour and minute will follow up as you press and release the... -
Page 8: Memory Recall
Memory Recall • You can recall stored data by pressing the “Memory Recall” switch at any time, EXCEPT while taking a measurement. • Up to 42 sets of measurement results can be stored in memory. Memory cell No. 1 is always used to store the newest set of results. -
Page 9: Description Of Display Marks
300mmHg. Batteries are weak. or no display There is a problem with the device. CORRECTIVE ACTION Please measure again. Please measure again. Please check the cuff and try again. Please measure again. Replace the batteries. Return to Lumiscope service Department. -
Page 10: Specifications
4. Consult your doctor if you have questions about your blood pressure or pulse. 5. Specifications are subject to change without notice due to improvements in performance. 1098 Full Fuzzy Auto, Oscillometric Method Left Wrist Soft Cuff 5.4 to 7.8 in. -
Page 11: Warranty
Repair Department. Service of this product by anyone other than Lumiscope Repair Department voids warranty. In the event that Lumiscope does not abide the terms of this warranty the con- sumer may seek breach of contract remedies in the New York State Federal courts of law.