Table of Contents
Advertisement
Available languages
Available languages
The lights do not work
A light bulb is loose in the socket or
burned out
Tighten or replace the light bulb. See "Changing the Light
Bulbs."
The dispenser light is set to OFF
On some models, the dispenser light will operate only when a
dispenser paddle is pressed. If you want the dispenser light to
stay on continuously, see "Water Dispenser."
The control is set to Sabbath Mode (on
Turn off Sabbath Mode. See "Using the Controls."
some models)
The refrigerator
seems
The compressor in your new refrigerator regulates
noisy
temperature more efficiently while using less energy, and
Below are listed some normal
operates quietly. Due to the reduction in operating noise you
sounds with explanations,
may notice more intermittent noises.
Sound of the compressor
High efficiency compressor and fans
This is normal. Larger, more efficient
running longer than expected
refrigerators run longer.
Pulsating/Whirring
Fans/compressor
adjusting to optimize performance during
This is normal
normal compressor operation
Popping
Contraction/expansion
of inside walls, especially during initial
This is normal
cool-down
Hissing/Dripping
Flow of refrigerant, or flow of oil in the compressor
This is normal
Vibration
The refrigerator may not be steady
Adjust the leveling screws and lower
the leveling foot firmly against the floor.
See "Door Closing and Door
Alignment."
Rattling/Banging
Movement of the water lines against the refrigerator cabinet,
Move excess water line away from the
or of items placed on top of the refrigerator cabinet
refrigerator cabinet or fasten excess
tubing to the cabinet. See "Connect
the Water Supply," or remove items
from the top of the refrigerator.
Sizzling
Water dripping on the heater during defrost cycle
This is normal
Water running/Gurgling
May be heard when ice melts during the defrost cycle and
This is normal
water runs into the drain pan
Buzzing
Heard when the water valve opens to fill the ice maker
This is normal
Creaking/Cracking
May be heard as ice is being ejected from the ice maker mold
This is normal
Ker-plunk
May be heard when the ice falls into the ice storage bin
This is normal
Temperature is too warm
The refrigerator has just been installed
Allow 24 hours following installation for the refrigerator to cool
completely.
Cooling is turned off
Turn on cooling. See "Using the Controls."
The controls are not set correctly for
Adjust the controls a setting colder. Check the temperature in
the surrounding conditions
24 hours. See "Using the Control(s)."
The door(s) are opened often or not
Allows warm air to enter refrigerator. Minimize door openings
closed completely
and keep doors fully closed.
A large load of food was recently
Allow several hours for refrigerator to return to normal
added
temperature.
18
Advertisement
Table of Contents
