KitchenAid KFFS20EYBL02 User Instructions page 19

Temperature is too cold in The refrigerator air vent(s) are blocked If the air vent located in the top, left, rear corner of the
the refrigerator/crisper refrigerator compartment is blocked by items placed directly
in front of it, the refrigerator will get too cold. Move items
away from the air vent.
The controls are not set correctly for Adjust the controls a setting warmer. Check the temperature
the surrounding conditions in 24 hours. See "Using the Controls."
The ice storage bin is not in the correct See "Ice Maker."
position
Temperature is too cold in The control is not set correctly for the Adjust the control setting. See "Refrigerator Features."
the pantry drawers items stored in drawer
There is interior moisture The room is humid A humid environment contributes to moisture buildup.
buildup ...........................................................................................................................................................................................................
NOTE: Some moisture The door(s) are opened often or not Allows humid air to enter the refrigerator. Minimize door
buildup is normal, closed completely openings and close doors completely.
The door is blocked open Move food packages away from door.
A bin or shelf is in the way Push bin or shelf back into the correct position.
Storing liquid in open containers This adds humidity to the refrigerator interior. Keep all
containers tightly covered.
There is frost/ice buildup in The doors are opened often or left Minimize door openings and keep doors fully closed.
the freezer compartment open
Poor door seal Ensure door seals are making full contact with the refrigerator
cabinet to allow for an adequate seal.
Temperature controls are not set See "Using the Controls" for recommended temperature
correctly settings.
The ice maker is not
producing ice or is not
producing enough ice
The refrigerator is not connected to a Connect refrigerator to water supply and turn water shutoff
water supply or the water supply valve fully open.
shutoff valve is not turned on
There is a kink in the water source line A kink in the line can reduce water flow. Straighten the water
source line.
The ice maker is not turned on Make sure the ice maker is on. See "Ice Maker."
The refrigerator has just been installed Wait 24 hours after ice maker installation for ice production to
begin. Wait 3 days for full ice production.
The refrigerator door is not closed Close the door firmly. If it does not close completely, see "The
completely doors will not close completely."
A large amount of ice was recently Allow 24 hours for ice maker to produce more ice.
removed
An ice cube is jammed in the ice maker Remove ice from the ejector arm with a plastic utensil.
ejector arm NOTE: On some models, press the lever which opens the ice
maker door to access the ejector arm.
A water filter is installed on the Remove the water filter and operate the ice maker. If ice
refrigerator volume improves, then the filter may be clogged or incorrectly
installed. Replace filter or reinstall it correctly.
A reverse osmosis water filtration This can decrease water pressure. See "Water Supply
system is connected to your cold Requirements."
water supply
19