Loading And Using The Dryer - Hotpoint HTDP120ED4WW Owner's Manual

Loading and using the dryer.
Always follow the fabric manufacturer's care label when laundering.
49-90506
Sorting and Loading Hints
As a general rule, if clothes are sorted properly for the
washer, they are sorted properly for the dryer.
Do not overload. Thiswastes energy and causes
wrinkling.
Do not add fabric softener sheetsonce the load has
become warm. Theymay cause fabric softener stains.
Bounce® Fabric Conditioner Dryer Sheets have been
approved for use in all GEDryers when usedin
accordance with the manufacturer's instructions.
Do not dry the following items: fiberglass items,
woolens, rubber-coated items,plastics, items with
plastic trim and foam-filled items.
Care and Cleaning of the Dryer
The Exterion Wipe or dust any spills or washing
compounds with a damp cloth. Dryer control panel
and finishes may be damaged by some laundry
pretreatment soil and stain remover products. Apply
these products away from the dryer. The fabric may
then be washed and dried normally. Damage to your
dryer caused by these products is not covered by your
warranty.
The Lint Filten Clean the lint filter before each use.
Hoisten your fingers and reach into the filter opening.
Run your fingers acrossthe filter. Have a qualified
technician vacuum the lint from the dryer once
a year.
The Exhaust Duct: Inspect and clean the exhaust
ducting at least once a year to prevent clogging. A
partially clogged exhaust can lengthen thedrying time.
Follow these steps:
L_J Turn off electrical supply by disconnecting the plug
from the wall socket.
[_ Disconnect the duct from the dryer.
[-_ Vacuum the duct with the hose attachment and
reconnect the duct.
The Exhaust Hood: Checkfrom the outside that the
flaps of the hood move freely when operating. Hake
sure that there is no wildlife (birds,insects,etc.)nesting
inside the duct or hood.
J