Using The Remote Control Unit; Loading Batteries; Effective Control Range - Panasonic PT-L6600E Operating Instructions Manual

Using the Remote control unit

Loading batteries

When loading batteries into the battery compartment
of the remote control, make sure that their polarities
are correct.
1. Open battery compartment lid.
Open lid in the order of steps
2. Insert the batteries
Into battery compartment, with their polarities
orientated as indicated (
3. Close battery compartment lid.
Replace the battery compartment lid over the
compartment and slide until it clicks.
Caution
• Exercise care not to drop the remote control
on hard flooring.
• Exercise care not to spill water or any other
liquid on the remote control.
• Do not use Ni-Cd batteries with this remote
control.
14
and .
/ ) in the compartment.
Accessory type-AAA dry
b a t t e r i e s ( i n s e r t t h e
negative side first).

Effective control range

The remote control should normally be aimed at either
the front or rear remote control receiver window on
the projector (fig. 1). Otherwise it may also be aimed
at the screen, which will reflect commands back to
the projector's front receiver window as illustrated in
figure 2.
The effective control range is approx. 7 metres (23
feet) immediately in front of the receiver windows.
(Front)
Remote
control
30
[Top view]
30
Remote
15
control
15
[Side view]
Screen
Remote control
receiver window
(Front)
Remote
control
Note
• When the remote control is aimed at the
screen, the effective control range may be
reduced due to the optical loss of the screen.
• The remote control may not function properly
if an object is in the light path.
• The remote control receiver may not function
properly in intense ambient light. Carefully site
the projector so its remote control receiver
windows will not be directly exposed to
intense light.
(Rear)
Remote
30
control
30
Remote
15
control
IN
IN OUT L R IN OUT OUT
IN OUT
RGB IN
S-VIDEO IN VIDEO AUDIO IN AUDIO AUDIO USB SERIAL
R/R-Y/P R G/Y B/B-Y/P B SYNC/HD VD OUT
RGB 1 IN RGB 2 IN RGB OUT REMOTE WIRED
IN OUT
DVI-D > PC < TBMU152
15
fig. 1
projector
IN OUT L R IN OUT
IN OUT IN OUT
RGB
S-VIDEO IN VIDEO AUDIO IN AUDIO AUDIO USB SERIAL IN
R/R-Y/P R G/Y B/B-Y/P B SYNC/HD VD OUT
RGB 1 IN RGB 2 IN RGB OUT REMOTE WIRED
IN DVI-D OUT > PC < TBMU152
Remote control
receiver window
(Rear)
fig. 2