Using The Remote Control As A Pc Mouse - Panasonic PT-L6600E Operating Instructions Manual

Using the Remote control unit

Using the remote control as a PC mouse

You can use the remote control as your PC mouse. Set the Mode (Projector/Computer) switch on the remote control
to Computer and connect the projector's USB port to your PC counterpart with the accessory USB cable.
OUT
UDIO
• When your PC is attached to the projector for the first time, the "new hardware wizard" will launch automatically.
When USB cable connects for the first time between projector and PC, the following massage appear from PC. The
reason that the driver not installed, therfore press "NEXT" button continuously and finally. Press "Finish".
The following is in the case of Windows
Note
• If you click "Cancel", the "new hardware wizard" launches each time your PC is connected to the projector.
Page button
R-CLICK button
Mode switch
(Computer/Projector)
Note
• The optional wireless receiver (Model ET-RMRC1) is needed for a PC not equipped with a USB port. However,
Page buttons do not function.
16
Projector
OUT
IN
IN OUT
USB SERIAL
RGB 2 IN RGB OUT REMOTE
button
Click button
IN
OUT
WIRED
> PC < TBMU152
Mode switch (Computer/Projector)
Mode switch is set to the Computer position.
• Page button
: Functions as the Page Up button on your PC
keyboard.
: Functions as the Page Down button on your PC
keyboard.
• Arrow (
These buttons functions as the cursor control buttons
on your PC.
• R-CLICK button
This button functions as the right button on your PC
mouse.
• Click button
This button functions as the left button on your PC
mouse.
Accessory PC equipped with
USB cable a USB port
) button