Setup Precautions - Panasonic PT-L6600E Operating Instructions Manual

Setup precautions

• Before connecting any of your video/audio equipment to the projector, carefully read the owners manual supplied
with the equipment once again.
• All cable connections should be made with the entire system devices, including the projector, first turned off.
• Obtain commercial interconnecting cables for devices supplied with no accessory or optional interconnect cables.
• Video signals containing too much jitter may cause the images on the screen to randomly wobble or shake. Inserting
a time base corrector (TBC) in the projector's video line will relieve this problem.
• The projector only accepts composite-video, S-video, analogue-RGB (with TTL sync. level), and digital signal from
PC.
• The projector contains built-in speakers. When greater sound output is required, use an audio amplifier connected
to the projector's AUDIO OUT jack. Once the cable is plugged into the AUDIO OUT jack, the audio signal lines to the
internal speakers are automatically cut off.
• Some PC models are not compatible with the PT-L6510E/L6600E projector.
• The pin assignments on the S-VIDEO IN port are as
follows:
Viewed from mating side
• The pin assignments on the RGB2 input port are as
follows:
Viewed from mating side
Pin : Not used.
Pins - , , and : Ground.
Pins and : Valid if the PC has the corresponding function.
Pin No. Signal
Ground (luminance)
Ground (colour)
Luminance signal
Colour signal
Pin No. Signal
R/P
R
G/G · SYNC/Y
P
B
SDA
HD/SYNC
VD
SCL
• The pin assignments on the DVI-D input port are as
follows (interface with TMDS port on PC):
Viewed from mating side
Pin No. Signal
T. M. D. S data 2-
T. M. D. S data 2+
T. M. D. S data 2/4
shield
T. M. D. S data 4-
T. M. D. S data 4+
DDC clock
DDC data
T. M. D. S data 1-
T. M. D. S data 1+
T. M. D. S data 1/3
shield
T. M. D. S data 3-
.
Pin No Signal
T. M. D. S data 3+
+5 V
Ground
Hot plug sense
T. M. D. S data 0-
T. M. D. S data 0+
T. M. D. S data 0/5
shield
T. M. D. S data 5-
T. M. D. S data 5+
T. M. D. S clock
shield
T. M. D. S clock+
T. M. D. S clock-
19