Lochinvar FTxl 500 Service Manual page 30

1
Service
Reset Maintenance Reminder
Once servicing has been completed, the service notification
counter should be reset. This parameter can be reset by
the installer by accessing the Reset Maintenance Reminder
parameter. Once accessed, press the RESET key to reset the
service notification counter.
Service Name and Phone Number
Please note that the brackets ([]) denote
NOTICE
screen status.
When a Maintenance Reminder timer or counter has expired,
a Maintenance Reminder screen will appear on the display.
By programming the installer's name and phone number,
this information will appear on the Maintenance Reminder
Screen at that time. This can be programmed by accessing
the Service Name and Phone Number parameter. When
selected, another menu will appear with PHONE and NAME.
1. Rotate the NAVIGATION dial to point to the
name/phone number to program and press the
NAVIGATION dial. The screen will now display the
selected item (either PHONE or NAME).
2. Press the NAVIGATION dial again.
appear at the bottom of the screen. By rotating the
NAVIGATION dial, various numbers and characters
will appear. When the desired number/character is
found, press the NAVIGATION dial. The cursor will
move to the next position.
3. Repeat this procedure until the entire message is
entered. If you make a mistake and wish to back up
one character, rotate the NAVIGATION dial until
the back arrow () character is displayed and press the
NAVIGATION dial.
4. When finished, press the RIGHT SELECT [SAVE] key
to return to the previous menu.
30
Basic Setup
The Basic Setup Menu contains the most frequently used
parameters from the list above. See the descriptions above to
set these parameters.
USB
Parameter files can be copied directly to and from a USB flash
drive. When USB is selected from the Main Menu, the display
will ask you to insert a flash drive into the USB-A (rectangular)
port next to the display. Once a drive is inserted, the display
will search the root directory of this drive for a folder named
"lochinvar". If it does not find it, the display will ask if you
want it to create this folder? Press either the [YES] or [NO]
key. If you press [NO], no further operations are allowed, so
you must remove the flash drive. If you press [YES], it will
create the folder in the flash drive. If the flash drive contains
a folder named lochinvar, the display will show all of the
parameter files stored in that folder.
If you wish to copy the parameters from the Smart System
control into the flash drive, press the [SAVE] key. The display
will create a file name based on the current date and time
(year-month-date-hours-minutes). If you wish to cancel this
operation, press the [NO] key. If you wish to change the
A cursor will
filename, press the NAVIGATION dial. The first character of
the filename will flash. Rotate the NAVIGATION dial to change
this character. Once it is correct, press the NAVIGATION dial
again, and edit the next character as before. When the new
filename is ready, press the [SAVE] key. The control will save
the parameters to the flash drive, and the new file will appear
in the list of parameter files. Press the [EXIT] key to return to
the Main Menu.
If you wish to copy a parameter file from the flash drive into
the Smart System control, rotate the NAVIGATION dial until
the file you wish to copy is selected. Press the NAVIGATION
dial once. The display will ask you if you want to load the
parameters from the file you selected. You can press [NO] to
cancel the operation, or press [YES] to continue with writing
the parameters into the control. Once the loading process is
complete, the display will return to the Main Status Screen.
Service Manual