Grandstream Networks GXP1160 User Manual page 49

Small-medium business ip phone
Hide thumbs Also See for GXP1160:
Table of Contents

Advertisement

Busy Tone
Reorder Tone
Call Waiting Tone Gain
Settings -> Audio Control
Headset Key Mode
Headset Type
Always Ring Speaker
Headset TX gain
FIRMWARE VERSION 1.0.7.4
ON is the period of ringing ("On time" in 'ms') while OFF is the period of
silence. In order to set a continuous ring, OFF should be zero. Otherwise
it will ring ON ms and a pause of OFF ms and then repeat the pattern. Up
to three cadences are supported.
Configures the call waiting tone gain to adjust call waiting tone volume.
The default setting is "Low".
When headset is connected to the phone, users could use the HEADSET
button in "Default Mode" or "Toggle Headset/Speaker".
Default Mode:
 When the phone is in idle, press HEADSET button to off hook
the phone and make calls by using headset. Headset icon will
display on the screen in dialing/talking status.
 When there is an incoming call, press HEADSET button to pick
up the call using headset.
 When there is an active call using headset, press HEADSET
button to hang up the call.
 When Speaker/Handset is being used in dialing/talking status,
press HEADSET button to switch to headset. Press it again to
hang up the call. Or press speaker/Handset to switch back to the
previous mode.
Toggle Headst/Speaker:
 When the phone is in idle, press HEADSET button to switch to
Headset mode. The headset icon will display on the left side of
the screen. In this mode, if pressing Speaker button or Line key
to off hook the phone, headset will be used.
 When there is an active call, press HEADSET button to toggle
between Headset and Speaker.
Selects headset type from Normal RJ9 headset or Plantronics EHS
headset. The default setting is "Normal".
Configures to enable or disable the speaker to ring when headset is used
on "Toggle Headset/Speaker" mode. If set to "Yes", when the phone is in
Headset "Toggle Headset/Speaker" mode, both headset and speaker will
ring on incoming call. The default setting is "No".
Configures the transmission gain of the headset. The default value is
0dB.
GXP1160/GXP1165 USER MANUAL
Page 47 of 67

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gxp1165

Table of Contents