Grandstream Networks GXP1160 User Manual page 48

Disable Call Waiting Tone
Disable Direct IP Call
Use Quick IP Call mode
Disable Conference
Disable in-call DTMF Display
Enable MPK sending DTMF
Disable Transfer
In-call dial number on pressing
transfer key
Auto-Attended Transfer
Do Not Escape # as %23 in
SIP URI
Click-To-Dial Feature
Blink message LED on ringing
Call History Flash Writing:
Write Timeout
Call History Flash Writing:
Max Unsaved Log
Settings -> Ring Tone
Call Progresses Tones:
System Ring Tone
Dial Tone
Second Dial Tone
Message Waiting
Ring Back Tone
Call-Waiting Tone
FIRMWARE VERSION 1.0.7.4
Disables the call waiting tone when call waiting is on. The default setting
is "No".
Disables Direct IP Call. The default setting is "No".
When set to "Yes", users can dial an IP address under the same
LAN/VPN segment by entering the last octet in the IP address. To dial
quick IP call, off hook the phone and dial #XXX (X is 0-9 and XXX
<=255), phone will make direct IP call to aaa.bbb.ccc.XXX where
aaa.bbb.ccc comes from the local IP address REGARDLESS of subnet
mask. #XX or #X are also valid so leading 0 is not required (but OK). No
SIP server is required to make quick IP call. The default setting is "No".
Disables the Conference function. The default setting is "No".
When it's set to "Yes", the DTMF digits entered during the call will not
display. The default setting is "No".
Enables Multi Purpose Key to send DTMF during the call. The default
setting is "No".
Disables the Transfer function. The default setting is "No".
Configures the number for the phone to dial as DTMF during the call
using TRAN button.
If set to "Yes", the phone will use attended transfer by default. The default
setting is "No".
Specifies whether to replace # by %23 or not for some special situations.
The default setting is "No".
Enables Click-To-Dial feature. The default setting is "Disabled".
Message LED light will blink if there is an incoming call. Default value is
"No".
Defines the interval (in seconds) to save the call history to phone's flash.
The default value is 300 seconds.
Defines the number of unsaved logs before written to phone's flash. The
default value is 200 entries.
Configures ring or tone frequencies based on parameters from local
telecom. The default value is North American standard. Frequencies
should be configured with known values to avoid uncomfortable high
pitch sounds.
Syntax: f1=val,f2=val[,c=on1/off1[-on2/off2[-on3/off3]]];
(Frequencies are in Hz and cadence on and off are in 10ms)
GXP1160/GXP1165 USER MANUAL Page 46 of 67