Table of Contents
Advertisement
1
6
4
2
3
(Fig. 2)
Removing the unit
1
DIN REAR-MOUNT
Installation using the screw holes on the both sides of the unit.
1
3
2
5
7
5
2
1. Dashboard
2. Nut (M5)
3. Spring Washer
4. Tapping Screw with Washer (M5 x 25)
5. Screw
6. Plain Washer
7. Backstrap
Be sure to use the backstrap to secure
the back of the unit in place.
The backstrap can be bent by hand to
the desired angle.
Note: The trim piece, backstrap, and mounting
bracket are not used for REAR-MOUNT.
1. Lever
Insert the levers supplied with the unit
into the grooves at both sides of the unit
as shown in figure until they click.
Pulling the levers upward and out to
makes it possible to remove the unit.
Fastening the unit to the factory radio
mounting bracket.
1. Select a position where the screw holes
of the bracket and the screw holes of
the main unit become aligned (are fitted),
5
and tighten the screws at 2 places on
each side.
4
Use either truss screws (5 x 5mm) or
screws (4 x 5mm), depending on the
shape of the screw holes in the bracket.
2. Screw
3. Factory Radio Mounting Bracket
4. Dashboard or Console
5. Hook and Screw (Remove this part)
Note: The frame, strap, and half-sleeve are
not used for REAR-MOUNT.
4
Advertisement
Table of Contents
