Troubleshooting - Bissell TOTAL FLOORS 63X4 SERIES User Manual

Troubleshooting

Problem
Vacuum cleaner won't run
Vacuum cleaner won't
pick up or low suction
Visible dust escaping
from vacuum
Other maintenance or service not included in the manual should be performed by an
Thank you for selecting a BISSELL product.
Please do not return this product to the store.
w w w . b i s s e l l . c o m
14
Possible causes
Vacuum cleaner is not plugged in
Power button is not pressed down
Tools, flex hose and/or telescoping
extension wand are blocked
Filters are dirty
Dirt cup is full
Flexible hose not securely attached
to suction opening
Crack or hole in flex hose
Variable suction control is set to
minimum setting
Dirt cup is full
Filters missing or installed
incorrectly
Filters are dirty
Flex hose is blocked
Flexible hose not securely attached
to suction opening
Crack or hole in flex hose
authorized service representative.
For any questions or concerns, please BISSELL at:
Canada Consumers : 1-800-263-2535
U.S. Consumers : 1-800-237-7691
WARNING:
To reduce the risk of electric
shock, turn power OFF and
disconnect plug from electrical
outlet before performing
maintenance or troubleshooting.
Remedies
Check electrical plug
Press power button down
Remove each part and check for
blockages
Check and clean or replace all
filters
Empty dirt cup
Make sure flexible hose is locked
into suction opening
Check hose and replace if needed
Change to increase setting or to
maximum.
Empty dirt cup
Check all filters for correct
installation
Check and clean or replace all
filters
Remove hose and check for
blockages
Make sure flexible hose is locked
into suction opening
Check hose and replace if needed
1 - 8 0 0 - 2 3 7 - 7 6 9 1