Operations - Bissell TOTAL FLOORS 63X4 SERIES User Manual

Operations

Power cord
The power cord is located at the rear of the
vacuum. Gently pull out the power cord,
watching for the yellow line. Stop pulling the
power cord once the yellow line is visible.
There is also a red line, which indicates
the end of the usable cord. Do not pull the
power cord out beyond the red line.
Automatic cord rewind
Your vacuum is equipped with an automatic
cord rewind. When cleaning is finished,
press the power button OFF (
grasp the plug to disconnect from the
electrical outlet. Hold the plug and press the
automatic cord rewind button to rewind the
cord automatically.
Power button
Turn the power on or off by pressing lightly
downward on the power button (
Thermal motor protection
An internal thermal protector has been
designed into your cleaner to protect it from
overheating. When the thermal protector
activates, the main vacuum motor will
stop operating. If this happens, proceed as
follows:
1. Turn the cleaner OFF and unplug from
electrical outlet.
2.
Check the cleaner for the source of
overheating problem (ie. Full dirt cup,dirty
filters or clog).
3. Fix the problem by following the steps in
the maintenance section of the user guide.
4. When the motor cools for approximately
30 minutes, the thermal protector will
reset and cleaning may continue. If the
cleaner will not turn on or the thermal
protector continues to activate, your
cleaner may need servicing. Call BISSELL
Consumer Care or visit the website.
w w w . b i s s e l l . c o m
8
) and
CAUTION:
Be careful to avoid injury as
).
cord retracts very quickly.
Power Button
CAUTION:
Before using your vacuum, make sure
that the dirt cup and all filters are in
place. Do not operate your vacuum
without the dirt cup and filters.
Automatic
Cord Rewind
Button
1 - 8 0 0 - 2 3 7 - 7 6 9 1