Body Solid FLP Assembly Instructions And User's Manual page 8

S T E P
4
Be careful to assemble all components
in the sequence they are presented.
S T E P
4 NOTE:
Be careful to assemble all components
Finger tighten all hardware in this step. Do Not wrench tighten until end of step 6.
in the sequence they are presented.
A. Install Pulleys (D1-A) and (D1-B) into Mainframe (A) by using:
Two A10 (M10x60 hex head bolt)
Two D5 (steel bushing)
Two B1 (M10 nylon lock nut)
B. Install Pulleys (D1-C) and (D1-D) into Connector Frame (E) using:
Two A6 (M10x50 hex head bolt)
Four C1 (M10 washer)
Two B1 (M10 nylon lock nut)
C. Attach Handle Bar (B) to Mainframe (A) using:
Two A1 (M10x130 hex head bolt)
Four C1 (M10 washer)
Two B1 (M10 nylon lock nut)
D. Insert End Cap (D8) into Pulley Frame (H). Attach Pulley Frame (H) to Mainframe (A) using:
One A1 (M10x130 hex head bolt)
Two C1 (M10 washer)
One B1 (M10 nylon lock nut)
E. Connect Pulley (D1-E) to Pulley Frame (H) using:
One Q ("L" pulley cable plate)
One C1 (M10 washer)
One B1 (M10 nylon lock nut)
F. Attach Pulley Mount (O) to Linkage Frame (L) using:
One A5 (M10x75 hex head bolt)
Two C1 (M10 washer)
One B1 (M10 nylon lock nut)
G. Assemble Pulley (D1-F) to Pulley Mount (O) using:
One Q ("L" pulley cable plate)
One A4 (M10x45 hex head bolt)
Two C1 (M10 washer)
One B1 (M10 nylon lock nut)
mm
0 10
0
Inch
20 30 40 50
1" 2"
60 70 80 90
8
3"
100 110 120 130
4" 5"
140 150
6"